CeriGlass ir speciāla stikla pulēšanas sistēma, kas izveidota no inovatīvās tehnikas, kas apvieno speciālas keramikas kopā ar vecākām nano sastāvdaļām un viegliem abrazīviem. CeriGlass dziļi attīra un pulē stikla virsmas. Tā ātri noņem skābā lietus nospiedumus, ūdens pilienus, ceļa satiksmes nosēdumus un putnu mēslus. Tas arī var noņemt vieglus līdz vidējus stikla tīrāmo slotiņu skrāpējumus.
Iezīmes: CeriGlass ir tik efektīvs, ka tas pat noņem vieglus līdz vidējus skrāpējumus. Tas atstāj stiklu kristālmirdzošu.
Papildus rokas puliera polsteris var tikt izmantots, lai noņemtu ūdens nogulsnes.
Ja vēlaties strādāt efektīvi uz plašiem ūdens nospiedumiem vai viegliem skrāpējumiem, izmantojiet stikla pulēšanas mašīnu un CarPro stikla pulēšanas polsteri.
Kad izmantots kopā ar mašīnu, šis līdzeklis var noņemt skrāpējumus no stikla, kurus radīja sāls, ceļa netīrumi, kas ieķērušies vējstikla slotiņās.
Izmanto arī, lai paspilgtinātu hromu un citas metāla virsmas.
Neizmantot uz tonētiem stikliem.
Dažos gadījumos var novērst mazus caurumus stiklā (atkarīgs no to dziļuma).
Ideal for cleaning glass, polish removal, interior and leather cleaning, wax buffing, general cleaning tasks and coating removal the cobra terry weave microfibre towels are high quality and soft 350gsm cloths with 70% polyester and 30% polyamide like our boa cloths don’t be fooled with cheaper 80/20 mix towels that could marr soft paintwork and gloss plastics.
Scratch free edgeless border (ultrasonic cut)
Size: 40 x 40
Wash and care instructions:
Wash seperate from other towels and polishing pads.
Hand wash with liquid soap or machine wash on a cotton setting at 40c with liquid soap that does not contain fabric softener this clogs microfibres.
Introducing the easiest way to avoid fog and condensation on your windshield and mirrors.
How often do you find yourself wiping down the interior of your windshield with your hands or pulling out of the driveway without being able to see clearly. Avoid foggy glass and mirrors with CarPro Fog Fight! As microscopic beads of water in the air attempt to form on the glass the super hydrophilic Fog Fight forces them not to form beads. Featuring a “below 20 Deg.” contact angle it becomes impossible for the moisture to form beads. Tested and proven in lab tests no fog or condensation formed on Fog Fight treated surfaces even over 60 minutes of boiling water.
In lab tests, no fog formed after 60 minutes over boiling water or a hundred cycles of heat-and-cold
Safe and effective on all glass, lens types
Cleaner and anti-fog treatment in one step
One application lasts over a month if untouched
(1) Fog Fight 100ml with sprayer
(1) Applicator Block
(2) 4″ x 4″ Suede Microfibers
(1) 8″ x 8″ Suede Microfibers
Shake well before use
Apply to dry surface: Spray on lightly and spread thin layer evenly with 4″ Suede wrapped around Foam Block Applicator (or with terry cloth microfiber)
Allow to cure before wiping off
23 to 70 Deg: Approximately 10 min
70 to 90 deg: Approximately 1-3 min
Do not touch, rub or clean with water the surface after applied
Avoid application during extremely humid conditions if possible
If surface is extremely dirty clean with CarPro Eraser or Fast glass towel
Keep in cool dry ventilated space.
Keep out of reach of children.
Durability : 1 month if not touched or wiped.
TIP : In very cold weather spray a fine mist on the surface, (
not too much)
and use a thicker MF for wiping off very well if necessary.
DLUX Long Life Trim Coat was engineered specifically for coating plastics as well as rubber and metal. It can be used on any wheel finish including clear coated, chrome, aluminum, and plastic. This coating is the pinnacle of Exterior Plastic protection and darkens the trim as well without leaving any slick greasy feel that washes off.
Suitable as a plastic and metal protector for engine components.
(1) CQUARTZ DLUX 30ml.
(1) orange Foam Block Applicator
(4) 10x10cm Suede MF applicators
Made from quality high grade organic silane. DLUX is a Silane-based glass coating, DLUX Contains more than 50% pure silica!
Restores faded trim to look like new.
Lays down a protective film which forms an extremely durable glass coating on top of any substrate it is applied to.
We have incorporated a totally different nano composition to bond hard to plastic surface and achieve a thick uniformed layer.
Dlux offers a semi permanent chemical bonding to surface pores
Very easy to apply with great UV protection, on all exterior substrates.
Can be used on textured or smooth plastic
DLUX also offers semi permanent protection of aluminum wheels & Plastic finished wheels.
On wheels, DLUX will repel dirt and dust with ease & aid in the removal of brake dust.
DLUX will leave a glossy finish and is entirely hydrophobic.
Heat resistance to 800c+
Durability: 12+ months
Average use for 4 wheels and plastic trim = 10-15ml.
Make sure the surface is cool and dry. (Do not apply to hot surfaces or in direct sun.)
Scrub surface with an all purpose cleaner and or water spot remover, rinse clean, and allow to dry.
Use ERASER to remove any residue left by the APC or oil film and wait until the cleaned area is completely dry.
Wet the applicator with 5-6 drops of DLUX and spread evenly across the surface.
Let cure for 1 minute before buffing.
in the case of wheels, apply to full face then buff, then full rear barrel allow 1 minute cure then buff
Allow the surface to cure for 1-3 hours without any moisture on its surface.
Completely cured with NO rain requires 24 hours. (Any water marks from rain must be wiped off during first 24Hrs as a precaution)
Never allow highly alkaline (ph12+) chemicals such as non-diluted all purpose cleaners to sit or dwell on the surface for extended periods. This may damage the coating.
Do not use for other purposes.
If it becomes sticky and tough to remove apply more dlux over the top and buff immediately then work in smaller sections after this or omit the 1 minute cure.
Rain‑X® Original Glass Water Repellent dramatically improves wet weather driving visibility. Simply apply the treatment to exterior glass and watch the raindrops fly off your windshield while driving. Rain‑X helps improve visibility by repelling rain, sleet and snow.
In tests conducted by a major university, better visibility improved driving response time up to a full second or more. At highway speeds, that’s almost four car lengths of extra stopping distance!
Improve all-weather visibility, safety and driving comfort
Helps easily remove frost, ice, salt, mud and bugs
Product Usage Instructions:
Clean and dry surfaces before treating
Apply in temperatures above 5 °C
Apply Rain‑X® to a small, folded, dry cloth
Wipe onto exterior glass using a firm, circular and overlapping motion
Allow product to dry; a slight haze may appear
Reapply Rain‑X® to ensure complete and uniform coverage
Remove final haze with a dry cloth or by sprinkling water onto the haze and wiping with a paper towel
Other Uses for Rain‑X® Original Glass Water Repellent:
Try Rain‑X® Original Glass Water Repellent on your glass shower door and home glass windows for more water beading magic!
Avoid using Rain‑X® Original Glass Water Repellent on plastic shower doors, glass shower doors with etching or frosting, plexiglass and fiber glass
Avoid using Rain‑X® Original Glass Water Repellent on any plastic surfaces, including motorcycle windshields, ATVs and solar panels
Microfiber – polishing cloth is fantastich new polishing cloth for cars and for cleaning paintwork and car valeting and all types of polishing cleaning. Microfibre – polishing cloth the perfect tool for especially designed for the car industry, car-washes and auto body repair industry.
Laser cut removable label. No risk of scratching maximum absorption. Weight : 420 gr/m² Composition : 70 % Polyester 30 % Polyamide Size : 40 x 40 cm.
ANGELWAX H2GO GLASS SEALANT – THE ULTIMATE RAIN REPELLENT
Designed and formulated to contend with even the wettest weather the UK has to offer, AngelWax H2GO rain repellant has been designed to create a hydrophobic coating on glass surfaces. This surface coating prevents rain and other unexpected water from remaining on windscreens, windows and makes driving in extreme weather conditions much safer.
Rain and any other water that does make contact with the surface of the glass will simply bead and roll off at speeds as low as 20mph making this one of the best performing rain repellents available today.
Angelwax H2GO has been rigorously tested in our laboratory and by the best detailers in the business to ensure that we have formulated yet another perfect product for your vehicle.
Available in 100ml & 250ml Bottles
Before applying Angelwax H2GO, thoroughly clean the surface of the glass to be treated with Angelwax Vision superior glass cleaner.
Spray Angelwax H2GO onto a clean, dry microfibre cloth or applicator and apply to the glass in a circular motion until the entire surface has been treated.
Leave to bond for approximately 10-15 minutes until a haze appears on the glass and remove with a second clean, dry microfibre cloth.